Zanussi ZCAN20FW1, User Manual

Page: 6 / 20

Overall dimensions
1)
D1 mm 545
1) the width, height and depth of the appliance
without the handle and feet
Space required in use
1)
H2 mm 945
W2 mm 1105
D2 mm 690
1) the height, width and depth of the appliance in-
cluding the handle, plus the space necessary for
free circulation of the cooling air
Overall space required in use
1)
H3 mm 1380
W2 mm 1105
D2 mm 690
1) the height, width and depth of the appliance in-
cluding the handle, plus the space necessary for
free circulation of the cooling air, plus the space
necessary to allow door opening to the minimum
angle permitting removal of all internal equipment
LOCATION
The appliance should be installed well away from
any sources of heat, such as radiators, boilers,
direct sunlight, etc.
• Place the appliance in a horizontal position on a
solid surface.
• Make sure that the appliance stands level and
on all four feet. This can be achieved by two
adjustable feet at the bottom in front.
• To achieve the best performance, do not place
the appliance below overhanging wall units.
• Make sure the air can circulate freely around the
appliance.
If, due to different installation, proper ventilation
requirements are not respected, the appliance
will function correctly but energy consumption
might increase slightly.
It must be possible to disconnect the
appliance from the mains power
supply. The plug must therefore be
easily accessible after installation.
POSITIONING
This appliance is not intended to be used as a built-
in appliance.
This appliance should be installed in a dry, well
ventilated indoor position.
This appliance is intended to be used at ambient
temperature ranging from 10°C to 43°C. The
correct operation of the appliance can only be
guaranteed within the specified temperature range.
If you have any doubts regarding
where to install the appliance, please
turn to the vendor, to our customer
service or to the nearest Authorised
Service Centre.
ELECTRICAL CONNECTION
CAUTION! Any electrical work
required to install this appliance
should be carried out by a qualified
electrician or competent person.
WARNING! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
The wires in the mains lead are coloured in
accordance with the following code:
A B
C
D
E
6