24
www.zanussi.com
Connecting the appliance to the power
supply
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency. Or it
should be possible to isolate the oven from
the supply by incorporating a switch in the
fixed wiring in accordance with the wiring
rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the cupboard,
see (A).
• Connect the appliance to a single phase
230-240V/50 Hz alternating current via a
correctly installed earth socket.
• The power supply cord may only be
replaced by an electrician.
• If the appliance is to be operated in a
non-European country, the supply voltage,
current type and frequency of the
appliance indicated on the rating plate
must correspond with the specification of
your power supply. The rating plate can be
found on the inside face of the control
panel.
• Before installing, tie a piece of string to the
power supply cord to facilitate connection
to point (A) when the appliance is being
installed.
• When inserting the appliance into the
high-sided cupboard, DO NOT crush the
power supply cord.
• Do not immerse the power supply cord or
plug in water or any other liquid.
(A)
Electrical connections
WARNING!
THIS APPLIANCE MUST BE
EARTHED
The manufacturer declines any liability should
this safety measure not be observed.
• If the plug that is fitted to your appliance is
not suitable for your socket outlet, it must
be cut off and the appropriate plug fitted.
• Remove the fuse from the cut off plug. The
cut off plug should then be disposed of to
prevent the hazard of shocks in case it should
be plugged into the 13 A socket in another
part of your home.
Important!
The wires in the mains lead are coloured in
accordance with the following code:
GREEN AND YELLOW
EARTH
BLUE
NEUTRAL
BROWN
LIVE
If you fit your own plug, the colours of the wires
in the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug, proceed as follows:
• Connect the green and yellow (earth) wire to
the terminal in the plug which is marked with
the letter ”E” or the earth symbol ( ) or
coloured green and yellow.
• Connect the blue (neutral) wire to the
terminal in the plug which is marked with the
letter ”N” or coloured black.
• Connect the brown (live) wire to the terminal
in the plug which is marked with the letter ”L”
or coloured red.
1_Zanussi_EN240_MS_AE25_Layout 1 13/09/2016 10:58 Page 24
