Zanussi ZBF6124A, User Manual

Page: 4 / 16

Control panel
1 2 3 4 5
1 Pilot light
2 Temperature regulator
3 Fast Freeze light
4 Fast Freeze switch
5 Alarm light
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
The pilot light will light up.
Important! If the temperature inside the appliance is too
high the Alarm light will blink. Active the Fast Freeze
function.
Switching off
To turn off the appliance, turn the Temperature regulator
to the "O" position.
The pilot light will switch off.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature regulator toward higher settings
to obtain the maximum coldness.
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important! If the ambient temperature is high or the
appliance is fully loaded, and the appliance is set to the
lowest temperatures, it may run continuously causing
frost to form on the rear wall. In this case the dial must be
set to a higher temperature to allow automatic defrosting
and therefore reduced energy consumption.
Fast Freeze function
You can activate the Fast Freeze function by pressing the
Fast Freeze switch.
The Fast Freeze light will light up.
This function stops automatically after 52 hours.
It is possible to deactivate the function at any time by
pressing Fast Freeze switch.
The Fast Freeze light will switch off.
Excessive temperature alarm
An increase in the temperature in a compartment (for ex-
ample due to an power failure) is indicated by flashing of
the Alarm light.
When normal conditions are restored the Alarm light will
switch off automatically.
First use
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm water
and some neutral soap so as to remove the typical smell
of a brand-new product, then dry thoroughly.
Important! Do not use detergents or abrasive powders,
as these will damage the finish.
4