by the earth symbol or coloured green and
yellow.
2. Connect the wire coloured blue to the terminal
either marked with the letter “N“ or coloured
black.
3. Connect the wire coloured brown to the
terminal either marked with the “L“ or coloured
red.
4. Check that no cut, or stray strands of wire is
present and the cord clamp (E) is secure over
the outer sheath.
Make sure the electricity supply voltage is the
same as that indicated on the appliance rating
plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp fuse (B).
In the event of having to change the fuse in the plug
supplied, a 13 amp ASTA approved (BS 1362)
fuse must be used.
WARNING! A cut off plug inserted
into a 13 amp socket is a serious
safety (shock) hazard. Ensure that it is
disposed of safely.
VENTILATION REQUIREMENTS
The airflow behind the appliance must be sufficient.
5 cm
min. 200cm
2
min.
200cm
2
DOOR REVERSIBILITY
1. Loosen and remove the upper pin and spacer.
2. Remove the upper door.
3. Loosen the middle hinge.
4.
Remove the door.
5. Remove the lower spacer.
6. Loosen the lower pin with a key.
7. Tighten the lower pin on the opposite side.
8. Install the lower spacer.
9. Install the door.
10. Tighten the spacer and the upper pin.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold (i.e.
in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.
In case you do not want to carry out
the above mentioned operations,
contact the nearest Authorised
Service Centre. The Authorised
Service specialist will carry out the
reversibility of the doors at your cost.
INSTALLING THE APPLIANCE
CAUTION! Make sure that the mains
cable can move freely.
1. If necessary cut the adhesive sealing strip and
then apply it to the appliance as shown in
figure.
11
