Zanussi ZBA22421SA, User Manual

Page: 9 / 12

Problem Possible cause Solution
Water flows on the floor. The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet to
the evaporative tray.
The temperature in the appliance
is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower temperature.
The door is not closed correct-
ly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products temperature
decrease to room temperature be-
fore storage.
Many food products are stored
at the same time.
Store less food products at the
same time.
The door has been opened of-
ten.
Open the door only if necessary.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Replacing the lamp
CAUTION!
Disconnect the plug from the mains
socket.
1. At the same time, with the fingers expand
up and down the transparent cover and
unhook it in the direction of the arrows.
1
1
2
2. Replace the lamp with one of the same
power and shape, specifically designed for
household appliances. (the maximum power
is shown on the light bulb cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Technical information
Technical data
Dimensions of the recess
www.zanussi.com 9