Zanussi WD1009, User Manual

Page: 27 / 28

Something not working?
54
Problem Possible cause
• The machine does not start up: • The door is not firmly closed. (E40)
• The machine is not plugged in or there is no power
at the socket.
• The main fuse has blown.
• The START/PAUSE button has not been
depressed.
• The DELAY START (ARRANQUE RETARDADO)
option has been selected.
• The machine does not fill: • The water tap is closed. (E10)
• The inlet hose is squashed or kinked. (E10)
• The filter in the inlet hose is blocked. (E10)
• The door is not properly closed. (E40)
• The machine fills then empties
immediately:
• The end of the drain hose is too low. Refer to
relevant paragraph in “water drainage” section.
• The machine does not empty
and/or does not spin:
• The drain hose is squashed or kinked. (E20)
• The option AGUA EN LA CUBA has been
selected.
• The drain filter is clogged. (E20)
• There is water on the floor: • Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• Unsatisfactory washing results: • Too little detergent or unsuitable detergent has
been used.
• Stubborn stains have not been treated prior to
washing.
• The correct temperature was not selected.
• Excessive laundry load.
• The machine vibrates or is
noisy:
• The transit bolts and packing have not been
removed.
• The support feet have not been adjusted.
• The laundry is not evenly distributed in the drum.
• Maybe there is very little laundry in the drum.
• The door will not open: • The programme is still running, the drum is turning.
• The door lock has not yet released.
• The water level is above the bottom edge of the door.
• The machine is heating the water.
Problems which you can resolve yourself.
During machine operation it is possible that one of the following alarm codes appears on the display:
- E10: problem with the water supply If at the end of the programme the alarm code EF0 is
- E20: problem with water draining displayed this means that the drain filter is clogged.
- E40: door open
Once the problem has been eliminated, press the START/PAUSE button to restart the programme. If after
all checks, the problem persists, contact your local Service Centre.
124970950 WD1009 e-gb 12-09-2000 15:44 Pagina 54