10
5. Select the required option(s)
Select
or Easy Iron if required, the corresponding
light illuminates.
6. Select the DELAY START
Before you start the programme
, if you wish to delay
the start, press the DELAY START button repeatedly, to
select the desired delay. The relevant light illuminates.
7. Start the programme
Before starting up the machine check that:
●
the appliance is plugged in
●
the water supply tap is turned on
●
the drain hose is correctly and securely positioned
●
the door and the detergent dispenser drawer are
closed.
To start the selected programme, press the
START/PAUSE button; the corresponding light stops
flashing.
The WASHING light illuminates.
The machine starts operating.
If you have chosen a
delayed start, the
machine will begin the
countdown.
Start/
Pause
4 H
2 H
12 H
8 H
Washing
End
Delay
Start
Half
Load
Easy
Iron
Options
8. Altering a programme
You can alter the programme before it starts.
When the programme has started, you can only reset it
by turning the programme selector dial to
O
and then
you can select the new programme.
The washing water remains in the tub.
Start the new programme by depressing the
START/PAUSE button.
9. Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light starts
to flash. Depress the button again to restart the programme.
10. Cancelling a programme
Turn the selector dial to
O
to cancel a programme which
is running. Now you can select a new programme.
11. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button.
If the door does not open, this means that the machine is
already heating, that the water level is above the bottom
edge of the door or that the drum is turning.
If you cannot open the door but you need to open it you
have to switch the machine off by turning the selector dial
to “
O
”. After about 2 minutes the door can be opened
(pay attention to the water level and temperature!).
12. At the end of the programme
The machine stops automatically.
If the Rinse Hold
option has been selected, the
phase light END is on and the door is blocked to
indicate that the water must be emptied out before
opening the door.
To do this first turn the programme selector dial to “
O
”
and then to drain programme
or spin programme
.
Release of the lock is also indicated by the coming on of
the END light.
Turn the programme selector dial to “
O
” to switch the
machine off. Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash, close the
water tap. Leave the door open to prevent the formation
of mildew and unpleasant smells.
