Zanussi Electrolux ZDF 411, User Manual

Page: 24 / 36

24
What to do if ...
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved
with the help of the indications described in the chart, without calling out an engineer.
Open the door and carry out the following suggested corrective actions.
●
The water tap is blocked or furred with limescale.
Clean the water tap.
●
The water tap is turned off.
Turn the water tap on.
●
The filter (where present) in the threaded hose
fitting at threaded hose fitting.
Clean the filter in the threaded hose fitting.
●
The water inlet hose has not been correctly laid
or it is bent or squashed.
Check the water inlet hose connection.
●
The sink spigot is blocked.
Clean out the sink spigot.
●
The water drain hose has not been correctly laid
or it is bent or squashed.
Check the water drain hose connection.
●
Close the water tap and contact your local
Service Force Centre.
●
The dishwasher door has not been properly
closed.
Close the door
●
The main plug is not plugged in.
Insert the mains plug
●
The fuse has blown in the household fuse box.
Replace the fuse.
●
Delay start has been selected.
If dishes are to be washed immediately, cancel
the delay start.
Once these checks have been carried out; close the dishwasher’s door and switch on the
appliance. Press the button of the programme that was running before the intervention of the
alarm. The programme will continue from the point at which it was interrupted.
IMPORTANT!
Remember to switch off the appliance before carrying out any corrective action.
Possible cause and solution Fault code and malfunction
appears in the digital display
The dishwasher does not fill with water.
appears in the digital display
The dishwasher will not drain.
appears in the digital display
Anti-flood device is activated.
The programme does not start.
117984 99/0en 24-07-2007 12:21 Pagina 24