In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs
to be open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off button
All the indicator lights of the programme selection buttons
illuminate (setting mode).
4. Setting and starting the programme
To select a programme, press the programme button of
the washing programme you wish to select (see "Washing
programmes" chart).
The corresponding indicator light remains illuminated
while the other programme buttons indicator lights turn off.
The start of the programme will occur only after the
closure of the door, until this moment you can modify the
selection made.
Close the dishwasher door, the programme will start
automatically.
5. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it’s absolutely necessary
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
Interrupt a washing programme in progress
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the point at
which it was interrupted.
Cancel a washing programme in progress
Open the dishwasher door.
Press simultaneously the function buttons 2 and 3 for
about 2 seconds, the indicator light of the button
corresponding to the running programme starts flashing for
about 2 seconds.
After about 2 seconds the indicator lights of all the
programme buttons will illuminate indicating that the
running programme has been cancelled and that the
machine has returned to setting mode.
(If a new washing programme will be selected, check that
there is detergent in the detergent dispenser).
6. End of the washing programme
The dishwasher will automatically stop and an audible
signal informs you of the end of the washing programme.
Open the door, the end indicator light is illuminated.
The indicator light of the programme just ended remains
on.
Switch off the dishwasher by pressing the On/Off button.
Wait a few minutes before removing the dishes; in this way
they will be cooler and the drying will be improved.
7. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
"3 in 1" function
This function can be selected together with all programmes.
Place the "3 in 1" combi detergent tablet in the detergent
dispenser.
Press the "On/Off" button.
Press the "3 in 1" function button: the correspondent
indicator light illuminates. Remember that if this function is
selected, it will remain active also for the following
programmes, until it will be deactivated by pressing the "3 in
1" function button (indicator light off).
Select the required washing programme.
Close the dishwasher’s door. The programme will start
automatically.
Once the programme is running, the "3 in 1" function can
NO longer be changed. If you want to exclude the "3 in 1"
function you have to cancel the programme setting (see
"To cancel a washing programme in progress") and then
deactivate the "3 in 1" function by pressing the "3 in 1"
button.
In this case you have to set a washing programme again.
With the use of "3 in 1" combi detergent tablets, the cycle
durations given in the "Washing programmes" chart may
change.
Starting a washing programme
35
