PII18GB
36
Once the correct position has
been found, open the door
and fasten the decor panel
on the lower section by
means of two long 4 x 40
screws provided, using the
holes through the inner door.
Fixing to the adjacent units
Insert the two fixing brackets into the slots provided in
the top front part of the dishwasher, as shown in the fig-
ure. Secure the brackets to adjacent units using two
3,5 x 16 screws for each bracket.
Important!
The dishwasher must be secured against tilting.
Therefore, make sure that the counter it is fitted
under, is suitably secured to a fixed structure
(adjacent kitchen cabinets, wall).
Attention!
When the dishwasher is secured to the kitchen
cabinets, do not drill any holes into the sides of
the machine.
Adjusting the door balance
The door of the dishwasher is balanced when it is
open in any position.
Fitting the decor panel may sometimes affect this bal-
ance. In this case it will be necessary to adjust the
balance as follows:
Half-open the door and regulate the screws located on
the kick plate.
By screwing or unscrewing these screws, the tension
of the door balancing springs is increased or
decreased respectively.
Attention!
The weight of the panel should be within the limits
given in the "dimensions of the panel", otherwise
balancing the door will not be possible.
Levelling
Make sure that the dishwasher door closes properly,
without rubbing on sides. Otherwise level the machine
by slightly screwing or unscrewing the two front feet
until perfect closure of the door is reached.
Kitchen plinth adjustment
To allow correct opening of
the door it is sometimes
necessary to cut the
kitchen plinth. Refer to the
cutting table below.
According to dimensions of
(a) and (b) as shown on
the figure, you will find on
the following table the
depth (x) of the cut to be
made on the plinth.
The dimensions (a) and (b) of the table are those
more frequently used in the kitchen furnitures.
II54
II10
II59
a
b
II15
II08
1 7 0 1 6 0 1 5 0 1 4 0 1 3 0 1 2 0 11 0 1 0 0
136 131 125 118 110 100 93 85
135 131 125 118 110 102 92 85
137 132 125 118 110 102 94 85
138 134 128 120 110 104 95 85
139 130 124 115 105 98 88
138 129 120 110 100 90
135 125 115 105 95
/
/
/
/
40
50
60
70
80
90
1 0 0
/
/
Height (a)*
Depth (b)
*
X
X
600 mm
(minimum)
Dimensions of the cut on the plinth
*dimensions in mm
