This dishwasher is designed to be fitted under a
kitchen counter or worksurface.
It is essential that the recess dimensions indicated
in the diagram are followed.
No further openings for venting of the dishwasher
are required, but only to let the water fill and drain
hose and power supply cable pass through.
The recess height may be anywhere between 820
and 880 mm from the floor since the dishwasher
incorporates adjustable feet (max 60 mm).
A distance of 2 mm should be allowed between the
top of the dishwasher and the counter top.
Adjusting the height of the appliance
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. The rear foot is adjusted by turning the screw in
the middle of the front kick plate to the left or
right.
Pads are supplied for the feet to make sliding the
appliance in and out of the recess easier.
To fit the pads, press them onto the feet.
If required, the dimensions of these pads can be
reduced by breaking them where marked.
Good levelling is essential for correct closure and
sealing of the door. When the appliance is correctly
levelled, the door will not catch on the levelling
spacers, either side of the cabinet.
If the door does not close correctly, loosen or
tighten the adjustable feet until the machine is
perfectly level.
Building-in
48
PFI20GB
575
max
600
596
555
max
600
+
-
550
max
596
820
880
÷
8
18
8
78
÷
II65
II52
