50
Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little plates over the
runners and screw in the screws provided (3.5x16
mm).
For the alignment of the kitchen unit door, if
necessary,
use the clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
Inner door reversal
Using a screwdriver release bracket (1) by pressing
on the internal spring (Fig. 9) and withdraw it from
its seat together with the door;
remove plug (2) and fit it in the hole left open on the
opposite side;
turn the door through 180°, remove the bracket (1)
and refit it on the opposite side.
Refit the door and insert the top pin and bottom
bracket (1), pushing it into place.
To ensure correct storage of food, the
door is fitted with a simple spring device which holds
it in the open position until it is properly closed.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
Fig. 8
PR35
Fig. 9
PR140
1
2
180°
TECHNICAL SPECIFICATION
The technical data is indicated in the rating plate on the left side inside the appliance.
GB
