7. Set the temperature regulator to obtain the
maximum coldness and run the appliance for at
least 3 hours using this setting.
Only after this time put the food back into the freezer
compartment.
Period of non-operation
When the appliance is not in use for long period, take
the following precautions:
1. Disconnect the appliance from electricity supply.
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all accessories.
5. Leave the doors open to prevent unpleasant
smells.
Troubleshooting
Warning! Refer to Safety chapters.
What to do if...
Problem
Possible cause
Solution
The appliance does not operate.
The appliance is switched off.
Switch on the appliance.
The mains plug is not connected to
the mains socket correctly.
Connect the mains plug to the
mains socket correctly.
There is no voltage in the mains
socket.
Connect a different electrical appli-
ance to the mains socket. Contact a
qualified electrician.
The appliance is noisy.
The appliance is not supported
properly.
Check if the appliance stands sta-
ble.
Acoustic or visual alarm is on.
The cabinet has been recently
switched on.
Refer to "Door Open Alarm" or
"High Temperature Alarm".
The temperature in the appliance is
too high.
Refer to "Door Open Alarm" or
"High Temperature Alarm".
The door is left open.
Close the door.
The compressor operates continual-
ly.
Temperature is set incorrectly.
Refer to "Control Panel" chapter.
Many food products were put in at
the same time.
Wait a few hours and then check
the temperature again.
The room temperature is too high.
Refer to "Installation" chapter.
Food products placed in the appli-
ance were too warm.
Allow food products to cool to room
temperature before storing.
The door is not closed correctly.
Refer to "Closing the door" section.
The FastFreeze function is switched
on.
Refer to "FastFreeze function" sec-
tion.
13
