The screen-printing zone must face the inner side of
the door. Make sure that after the installation the sur-
face of the glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass panel in
the seats correctly.
A
How to replace: Lamp
Warning! Risk of electric shock.
The lamp can be hot.
Always hold the halogen lamp with a cloth to prevent
grease residue from burning on the lamp.
Before you replace the lamp:
Step 1
Step 2
Step 3
Turn off the oven. Wait until the
oven is cold.
Disconnect the oven from the
mains.
Put a cloth on the bottom of the cav-
ity.
Back lamp
Step 1
Turn the glass cover to remove it.
Step 2
Clean the glass cover.
Step 3
Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4
Install the glass cover.
Troubleshooting
Warning! Refer to Safety chapters.
What to do if...
In any cases not included in this table please contact
with an Authorised Service Centre.
Problem
Check if...
The oven does not heat
up.
The fuse is blown.
The door gasket is dam-
aged.
Do not use the oven.
Contact an Authorised
Service Centre.
Problem
Check if...
The display shows
"12.00".
There was a power cut.
Set the time of day.
The water leaks out of
the cavity embossment.
There is too much water
in the cavity emboss-
ment.
Unsatisfying cooking
performance of the func-
tion: True Fan Cooking
PLUS .
You filled the cavity em-
bossment with water.
The lamp does not work.
The lamp is burnt out.
Service data
If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre.
39
