• Adjust the level of the water softener according to
the water hardness.
• Activate or deactivate the acoustic signal indicating
the end of a programme.
• Activate or deactivate AirDry.
Before entering the user mode, make sure the
appliance is in the programme selection mode.
To enter the user mode:
Press and hold simultaneously
and
for at least
3 seconds.
The indicators:
,
, and
start flashing.
As the appliance stores the saved settings, there is no
need to configure it before every cycle.
Adjusting the water softener
Make sure the appliance is in user mode.
1. Press
.
The indicators
and
are off. The indicator
still flashes.
The indicator
starts flashing. The number of
flashes indicates the current water softener setting (e.g.
5 f pause + 5 flashes... = level 5).
2. Press
to change the setting. Each pressing
of the button
increases the level number
by one. After reaching level 10, the count starts
from level 1.
3. Press on/off to confirm and save the setting.
The water hardness table
German degrees
(°dH)
French degrees
(°fH)
mmol/l
Clarke degrees
Water softener lev-
el
47 -50
84 - 90
8.4 - 9.0
58 - 63
10
43 - 46
76 - 83
7.6 - 8.3
53 - 57
9
37 - 42
65 - 75
6.5 - 7.5
46 - 52
8
29 - 36
51 - 64
5.1 - 6.4
36 - 45
7
23 - 28
40 - 50
4.0 - 5.0
28 - 35
6
19 - 22
33 - 39
3.3 - 3.9
23 - 27
5 1)
15 - 18
26 - 32
2.6 - 3.2
18 - 22
4
11 - 14
19 - 25
1.9 - 2.5
13 - 17
3
4 - 10
7 - 18
0.7 - 1.8
5 - 12
2
<4
<7
<0.7
< 5
1 2)
1) Factory setting
2) Do not use salt at this level.
Activating the acoustic signal at the end of a
programme
Make sure the appliance is in user mode.
1. Press
.
The indicators:
and
are off. The indicator
still flashes.
The indicator
shows the current setting. If on = the
acoustic signal is active. If off = the acoustic signal is
disabled.
2. Press
to change the setting.
3. Press on/off to confirm and save the setting.
21
