recommend to run long duration programmes at
least 2 times per month.
• To maintain the performance of your appliance at its
best, we recommend to use monthly a specific
cleaning product for dishwashers. Follow carefully
the instructions on the packaging of the product.
Troubleshooting
If the appliance does not start or it stops during
operation, before you contact an Authorised Service
Centre, check if you can solve the problem by yourself
with the help of the information in the table.
With some problems the end indicator flashes
intermittently indicating a malfunction.
Problem and alarm code
Possible solution
You cannot activate the appliance.
•
Make sure that the mains plug is connected to the mains
socket.
•
Make sure that there is no damaged fuse in the fuse box.
The programme does not start.
•
Make sure that the appliance door is closed.
•
The appliance has started the procedure to recharge the res-
in inside the water softener. The duration of the procedure is
approximately 5 minutes.
The appliance does not fill with water.
•
The end indicator flashes 1 time intermittent-
ly.
•
Acoustic signal sounds 1 time intermittently.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the water.
•
The end indicator flashes 2 times intermit-
tently.
•
Acoustic signal sounds 2 times intermittently.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
•
The end indicator flashes 3 times intermit-
tently.
•
Acoustic signal sounds 3 times intermittently.
•
Close the water tap and contact an Authorised Service Cen-
tre.
Once you have checked the appliance, deactivate and
activate the appliance. If the problem occurs again,
contact an Authorised Service Centre.
For alarm codes not described in the table, contact an
Authorised Service Centre.
The washing and drying results are not satisfactory
Problem
Possible solution
There are whitish streaks or bluish lay-
ers on glasses and dishes.
•
The release quantity of rinse aid is too much. Adjust the rinse aid selec-
tor to a lower position.
•
The quantity of detergent is too much.
23