Troubleshooting
If the appliance does not start or it stops during
operation, before you contact the Service, check if you
can solve the problem by yourself with the help of the
information in the table.
With some problems different indicators flash
intermittently and/or continuously to show an alarm
code.
Problem and alarm code
Possible solution
You cannot activate the appliance.
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that there is no a damage fuse in the fuse box.
The programme does not start.
•
Make sure that the appliance door is closed.
•
Press Start.
•
If the delay start is set, cancel the setting or wait for the end of the
countdown.
•
The appliance has started the procedure to recharge the resin in-
side the water softener. The duration of the procedure is approxi-
mately 5 minutes.
The appliance does not fill with water.
•
The indicator
flashes 1 time in-
termittently.
•
The indicator Start flashes continu-
ously.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the water.
•
The indicator
flashes 2 times in-
termittently.
•
The indicator Start flashes continu-
ously.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
•
The indicator
flashes 3 times in-
termittently.
•
The indicator Start flashes continu-
ously.
•
Close the water tap and contact the Service.
Once you have checked the appliance, press Start . If
the problem occurs again, contact the Service.
For alarm codes not described in the table, contact the
Service.
The washing and drying results are not satisfactory
Problem
Possible solution
There are whitish streaks or bluish lay-
ers on glasses and dishes.
•
The release quantity of rinse aid is too much. Adjust the rinse aid selec-
tor to a lower position.
•
The quantity of detergent is too much.
There are stains and dry water drops
on glasses and dishes.
•
The released quantity of rinse aid is not sufficient. Adjust the rinse aid
selector to a higher position.
•
The quality of the rinse aid can be the cause.
23
