MOUNTING
The sensor can be mounted in any place by means of double-sided adhesive tape or
wall plugs 5x(3x30) mm.
Mounting by means of wall plugs:
Remove the upper cover - to do it put a screwdriver into a slot between the cover
and the base and switch it lifting up the cover at the same time.
Choose a place on the wall to mount the RCR-01 device, make two holes corre-
sponding mounting holes from the transmitter’s base.
Set wall plugs in the holes.
Fix the base by means of tightening screws into wall plugs.
Place the upper cover’s latches into the latches of the base.
CAUTION: The device has factory mounted batteries secured with special sep-
arator. Before the first device use remove the separator.
Sensitivity potentiometer
PROG push-button
Optic signalling range of operation
Motion sensor lens
Battery bases
Switches of operation modes
Sensitivity potentiometer
PROG push-button
Optic signalling range of operation
Motion sensor lens
Battery bases
Switches of operation modes
PROGRAMMING OF RECEIVERS
Mode 1.
Motion sensor
(operation modes’ switches in C-C position)
In this mode the receiver should be programmed to operate in time mode; time should be
adjusted to 15 seconds. When there is a movement within detection area the device sends
a signal to the receiver every 10 seconds. After a signal has been sent, adjusted time t is
counted again.
CAUTION: After each pressing of a push-button in a sensor, there are 10 seconds to
start the next programming step. After 10 seconds LED diode switches off in the sen-
sor and RCR-01 device starts usual operation (programming procedure must be started
again.
Press PROG push-button of RCR-01, next release the push-button. LED red diode
switches on under the lens (constant signal).
Press PROG push-button to adjust the receiver to programming mode. LED red diode
in the receiver switches on (constant signal).
Press PROG push-button of RCR-01 device and then release it. LED red diode in the
receiver switches on (first signal pulsates, next the signal is constant).
Press PROG push-button of RCR-01 device and then release it. LED red diode in the re-
ceiver switches on (signal pulsates), and then switches off - THE SENSOR IS ADDED.
Wait until LED diode in RCR-01 device switches off.
Mode 2.
Motion sensor with twilight switch
(operation modes’ switches in F-F posi-
tion).
In this mode the receiver should be programmed to operate in monostable mode.
When there is a movement within detection area the sensor sends a switch on signal
to the receiver.
The sensor sends a switch off signal after 20 seconds from the moment of no move-
ment in the detection area.
Press PROG push-button of RCR-01device, next release the push-button. LED red di-
ode switches on under the lens (constant signal).
Press PROG push-button of RCR-01 device again for a longer time.
Press PROG pushbutton to adjust the receiver to the programming mode. LED red
diode in the receiver switches on (constant signal).
Release PROG pushbutton of RCR-01 device. LED red diode in the receiver switches
on (first signal pulsates, next the signal is constant).
Press PROG push-button of RCR-01 device and then release it. LED red diode in the re-
ceiver switches on (signal pulsates), and then switches off - THE SENSOR IS ADDED.
Wait until LED diode in RCR-01 device switches off.
An exemplary programming procedure with the use of RWL-01 receiver.
The procedure for the rest of radio EXTA FREE transmitters is analogous.
