NOTES
INSTALLATION & CONNECTION
RELAY CAPACITY
1. Select the device installation site.
2. Disconnect the power supply circuit with a fuse, circuit break-
er or switch disconnector connected to an appropriate circuit.
3. Check the de-energized condition on the power supply ca-
bles by means of the appropriate instrument.
4. Install the device in its ultimate position. Use the installation
holes on the sides of the device for fixing it.
5. Adjust the device using the following switches:
P1: Light intensity, at which motion will be detected. When
the switch is moved to its upper position, the device will
be started at night. When the switch is moved down - the
device will operate continuously, regardless of the light
intensity.
P2: Sensor effective range selection The sensor can detect
within the range of ca. 3 m (lower position) or ca. 6 m
(upper position).
P3-P8: Light up time selection. The time, in which light will
go on is selected by moving the respective switch, e.g.
move the switch to the symbol “5” to set a 5-second light
up time.
6. Connect the cables in line with the connection diagram.
7. Connect the sensor included in the set.
8. Specify the supply voltage. The device automatically adapts
to the operating conditions. The device will be ready to work
after about 30-40 seconds.
• Since the device analyzes changes in
infrared radiation caused by thermal
changes occurring in the monitored area
to detect motion, it should not be installed:
- opposite light-reflecting surfaces, such
as mirrors,
- in the vicinity of heat sources, such as
radiators, fireplaces, air conditioners,
high-power lamps, etc.,
- in the vicinity of objects which can be
moved by gusts of wind, such as cur-
tains, tall plants, bushes, etc.
• The device should be installed at ca. 2÷4
m from the ground. Then, the monitored
area will be ca. 3 or 6 m in diameter.
800 W
400 W
200 W
300 W
15 W
WARRANTY CARD
24-month commercial warranty
granted by the manufacturer
Seller’s stamp and signature with date of sale
1. ZAMEL Sp. z o.o. grants a 24-month warranty for the goods it sells.
2. The warranty granted by ZAMEL Sp. z o.o. does not cover:
a) mechanical damage caused by transport, loading/unloading or other circumstances,
b) any damage resulting from improper installation or use of the goods sold by ZAMEL Sp. z o.o.,
c) any damage resulting from any modifications made by the BUYER or any third party to the sold goods or to the equipment
required for the proper functioning of the sold goods,
d) damage caused by any force majeure event or another fortuitous event beyond any reasonable control of ZAMEL Sp. z o.o.
3. The BUYER shall report all warranty claims in writing at the point of sale or to ZAMEL Sp. z o.o.
4. ZAMEL Sp. z o.o. will examine each warranty claim as regulated by the applicable provisions of the Polish law.
5. The form of warranty claim resolution, i.e. replacement, repair or refund of the price of purchase, shall be decided upon by
ZAMEL Sp. z o.o.
6. This warranty does not exclude, limit or suspend any rights of the BUYER arising from the statutory or regulatory laws con-
cerning implied warranty for defects of sold goods.
6 m
3 m
360°
2,2 ÷ 4 m
6 m
3 m
red
230 V AC 50/60 Hz
Operating range:
3 m / 6 m
Activation time:
5 s, 30 s, 1 min.,
3 min., 5 min.,
8 min.
Illumination level:
nigh / continuous
brown
blue
5˝30˝ 1΄
1 2 3 4 5 6 7 8
3΄ 5΄ 8΄
ON
