Installation & Getting Started
- 4 -
1. General Safety Information
Before installing the instrument, please read this information carefully for your safety and for the safety
of your system. In the following, we refer to the workstations Zennium-X, Zennium-pro, Zennium,
Zennium-E and Zennium-P600 as
Zennium-ECW
(ElectroChemical Workstation). In case only one of
these models is addressed, we refer to its name explicitly.
Only authorized personnel is allowed to open Zahner devices!
There are no user-serviceable
parts inside. Non-insulated parts under voltage inside may cause an electric shock when touched.
Front panels must not be removed while the instrument is connected to mains power. Before
removing a front panel, switch off the device and disconnect it from mains.
Extension cards are
installed to the extension slots to the right-hand side to the
Signal Processor
module. Do not install
extension cards to the left of the
Signal Processor
module.
Signal Processor Module
Expansion Card Slots
Please strictly follow all instructions written on the
Zennium-ECW
case, on tags attached to the case
and in the manuals for your own safety and for the safety of your system. Especially, strictly observe
the following:
!
Connect the
Zennium-ECW
only to the mains voltage shown on the mains plug/fuse
holder on the backside of the instrument cabinet!
!
If the system is not used for a longer time, the mains should be disconnected!
!
The system must be protected from water, any liquid and humidity above 65%!
!
Do not operate the instrument at environmental temperature higher than 40°
C!
!
Never place the system close to a heat source!
!
Always place the system in a position which allows sufficient ventilation through all
ventilation openings. Never place the system on top of a soft base!
!
Do not clean the system with aggressive agents or with hard objects!
!
In case of communication problems deactivate all power-safe modes (usb, harddisk,
screen, etc.) and screen-safers on the instrument computer!
!
Do not open the devices. There are no user-serviceable parts inside.