© 2011 Zadro Health Solutions, Inc.
Printed in China
Z
adro Health Solutions, Inc.
Innovative Ideas That Make Life Easier
TM
Huntington Beach, CA 92649
(714) 892-9200 FAX (714) 892-7477
E-Mail Address: [email protected]
Website: www.zadrohs.com
Rev.08242011
Troubleshooting:
Why does the dual scanner not turn on?
1. Make sure the AAA alkaline batteries are new
and do not need to be replaced.
2. Check the polarity of the batteries. Make sure
the battery cover is properly inserted.
3. Remove the protective cover as it controls the
main power switch.
4. Press and hold the “Power” button for 3
seconds.
Why does the Nano-UV™ light not turn on?
For Surface Disinfection Mode:
The Nano-UV™ light will only turn on if it is in the
original position inside the chamber. It will turn
off automatically if the Nano-UV™ light wand is
flipped out.
For Water Disinfection Mode:
Check that the two sensor pins located on the
black portion of the Nano-UV™ light wand are
completely immersed in water.
Why does the Nano-UV™ light appear dim
when immersed in water?
• Make sure that the Nano-UV™ light wand is
allowed to warm up for 30 seconds (3 times @10
seconds) in Surface Disinfection mode before
changing to Water Disinfection mode. Then
immerse the Nano-UV™ light wand in the water.
• For cool water, repeat the disinfection process
multiple times. This dual scanner is not intended
for use in very cold water.
Can more than 500ml (2 cups) of water be
disinfected in 40 seconds?
Water disinfection of more than 500mls (2 cups)
requires additional exposure to the Nano-UV™
light. You should repeat the disinfection process
multiple times when greater than 500mls (2 cups)
of clear water is disinfected.
Why does the UV light still turn on when the
tube is out of water?
Check the water remaining on the two Sensor
Pins. Simply blow away any water drops between
the two pins.
