Z3Cam-4K Camera Installation Instructions
DOC-USR-0106-01
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
3
1.0
OVERVIEW
If you will be providing your own Sony FCB-ER8300 4K camera block for a full Z3Cam-4K unit, you have
received a partially assembled system and will need to complete final assembly per the following
instructions.
These instructions assume that the electronics were correctly assembled into the Z3Cam-4K enclosure
bottom with all necessary thermal management solutions. Board level thermal management includes
two thermal pads between the Main Encoder PCB and the Interface Front End PCB as well as a copper
strip from the Main Encoder PCB to the chassis/enclosure.
Enclosures delivered by Z3 Technology are pre-assembled with the proper thermal components.
Electronics provided without the enclosure do not have the proper thermal materials and require
proper installation. Failure to implement appropriate thermal management may result in improper
operation or damage to the electronics or camera block.
2.0
MATERIALS
1x Sony FCB-ER8300 4K camera block (
not included
)
1x Z3Cam-4K enclosure bottom with electronics pre-assembled by Z3 Technology
1x Z3Cam-4K enclosure top
1x Thermal Pad 40 x 25 x 2.5 mm
1x KEL ribbon cable
16x M2 x 3 mm black finishing screws
4x Rubber feet (
optional
)
3.0
ADHESIVE THERMAL PAD AND CAMERA ASSEMBLY
(1)
Locate the silver heat sink within the Z3Cam-4K enclosure bottom assembly, and place the 40 x 25 x
2.5 mm thermal pad on the heat sink centered and aligned at the top.
Figure 1 Thermal Pad Placement on Silver Heat Sink
