DOC-USR-0135-01
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
42
7.0
STREAMING RTMP IN THREE DIFFERENT RESOLUTIONS
This section shows how to use the Z3-SBE264-10 to take one video input and stream it over RTMP into three
different resolutions (720p, D1, and CIF). Z3 Technology is a member of the Wowza Media Systems™
Technology Alliance partner program, and the Wowza Streaming Engine™ is used here as an example.
These instructions can also be used as an example of how to stream the same input into multiple
configurations. Simply specify “RTP”, “UDP”, or “TSFILE” instead of “RTMP”, and ignore the sections
referring to Wowza in this section. Note that, if multiple channels off the same input is done, the total
performance cannot exceed the capability of the Z3-SBE264-10 (for example, three 1080p30 encodes at
30fps would not be allowed. For multiple encodes the Z3-SBE264-10 can support the equivalent of 1x 1080i
1x 720p encode).
7.1
Connect the Encoder
(1)
Follow steps (1) to (9) in Section 6.0 to connect the Z3-SBE264-10 for encode and bring up the user
interface.
7.2
Configure the Encoder for “Multiple Output from One Input” Mode
(2)
At the bottom of the screen, select “Encode 1 to 3 Ch” using the dropdown menu.
7.3
Configure CH1 for RTMP Streaming
(3)
Click on the “CH1” tab.
(4)
Set “Video Source” to “HD-SDI”.
(5)
Set “Video Resolution” to “1280x720”.
(6)
Set “Video Bit Rate” to “4000K”.
(7)
Set Output Format to “RTMP.”
Change to “Encode 1
to 3 Ch” Mode
Figure 45 Changing to “Encode 1 to 3 Ch” Mode
(1)
