CONFIDENTIAL
DOC-USR-0030-12
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
9
2.0
QUICK START GUIDE
2.1
If You Have Received a System from Z3 with the Software Preloaded
To start working with the encoder, you can go straight to Section 7.0, “RUNNING THE ENCODER,” on page
19. This section describes how to quickly generate a UDP or RTP stream to VLC, how to change bitrate
dynamically, how to adjust the UDP TS rate, tuning for latency, and using DHCP. Details on running the
Decoder can be found in Section 8.0, “RUNNING THE DECODER”, on page 37.
2.2
If You Already Have a System from Z3 and Need to Update the Firmware
You can update the firmware via the web GUI interface by following the instructions in Section 10.0:
“RUNNING THE CODE YOU BUILT ON THE BOARD”, on page 42.
2.3
If You are Ready to Start Development
Details on how to untar and build the code can be found in Section 5.0: “UNTARRING AND BUILDING THE
SAMPLE CODE,” on page 12. A brief overview of the code itself can be found in Section 6.0: “CODE
OVERVIEW” on page 14.
Details on how to set up your system to access the code you have built can be found in Section 10.0:
“RUNNING THE CODE YOU BUILT ON THE BOARD”, on page 42.
