CONFIDENTIAL
DOC-USR-0012-08
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
25
For Composite, both inputs use the same input port as Component 1 (Figure
). In this case, the
yellow connector is connected to Composite 1, and the red connector to Composite 2 (Figure 14).
*
Note-
if component encode is being done, passthrough of the content being encoded can be seen by
plugging “A/V Out” on the Z3-DM8107-RPS to a monitor (see Figure 1).
HDMI1, Component1, and Composite1 are all accessible from the “CH1” tab. HDMI2, Component2,
and Composite2 are all accessible from the “CH2” tab.
Most combinations are allowed. However, because of the way the hardware is configured within the
Z3-DM8107-RPS, two combinations are not allowed. For both of those combinations, an alternative is
available.
below shows the combinations that are allowed and not allowed on the Z3-
DM8107-RPS.
CH1
CH2
Allowed? Notes
HDMI1
HDMI2
Yes
Component1 Component2 Yes
Composite1 Composite2 Yes
HDMI1
Component2 Yes
HDMI1
Composite2 No
Use Comp HDMI2 instead
Component1 HDMI2
Yes
Component1 Composite2 No
Use Comp Component2 instead
Composite1 HDMI2
Yes
Composite1 Component2 Yes
Figure 15 Allowed Input Combinations on the Z3-DM8107-RPS
Composite 1
Composite 2
Figure 14 Mapping of A/V Cable to Composite 1/2
