Z-World PK2300, User Manual

Page: 44 / 139

PK2300 44 s System Development
Refer to your Dynamic C manuals for more information
about single-stepping.
$
Use caution when connecting any device to a high-current
driver, making sure that you do not exceed the high-current
driver’s voltage and current limitations. Refer to Appendix
B, “Specifications,” for complete specifications on high-
current drivers.
5. Using the Dynamic C command
F8
(run/step over), single-step through
your program to the line marked A . At this point, your device should
be “OFF.” If your device is not OFF, verify your hardware connections
and the program.
6. Using the Dynamic C command
F8
(run/step over), single-step through
your program to the line marked B . At this point, your device should
be “ON.” If your device is not ON, verify your hardware connections
and the program.
7. Using the Dynamic C command
F8
(run/step over), single-step through
your program to the line marked C . At this point, your device should
be “OFF” again. If your device is not OFF, verify your connections
and the program.
8. Continue to press
F8
until the program terminates.
9. Repeat steps 5 through 8 as necessary.