2
7. If several windows need to be protected, adopt the wire according to the
specifications as mentioned below. This should be wired to the terminal block
provided in the battery compartment in series connection. The wired contact
should be connected using two core (24AWG) wire of maximum length 4m.
A cable entry cut-out is available and adjacent to the terminal block.
Internal connection
External wired connection
Choose either the internal or external wired connection, both of which types cannot
be in existence at the same time.
Note:
After removing batteries, wait for 5 seconds to refit batteries.
Operation
1. With the tamper switch not being pressed, the unit enters test mode, which
allows the user to make a test. Detach the magnet from the Sensor, the red
indicator LED on the Sensor will illuminate and the load or the lamp plugged into
the On/Off Module HSS-A10, Lamp Module HSS-A20 will turn ON. It implies that
the unit is working properly.
Close the door/window by replacing the magnet to the Sensor will turn OFF the
load or the lamp plugged into the On/Off Module HSS-A10, Lamp Module
HSS-A20 and the red indicator LED on the connected load or lamp will be off too.
2. When the tamper switch is pressed, the unit enters normal mode. Open the
door/window to detach the magnet from the Sensor will turn ON the load or the
lamp plugged into the On/Off Module HSS-A10, Lamp Module HSS-A20.
Close the door/window by replacing the magnet to the Sensor will turn OFF the
load or the lamp plugged into the On/Off Module HSS-A10, Lamp Module
HSS-A20.
In normal mode with the tamper switch being pressed, the red indicator LED on
the Sensor will not illuminate to conserve battery life when the sensor is triggered,
(unless the battery is low).
3. By pressing the tamper switch for more than 5 seconds, and then release it. The
Sensor will send an alarm command
(ALARM_REPORT, Alarm Type == 0x01,
Alarm Level == 0x11)
to the module, of which load or the lamp plugged into the
On/Off Module HSS-A10 or Lamp Module HSS-A20 will flash for 10 seconds.
Advanced Operation
The following information is for someone that has some experience setting up a
Z-Wave system or someone that has computer software running a Z-Wave
controller.
Enabling/Disabling Power Saving Function (for testing)
When the magnet is parted or closed from the Sensor for 10 seconds, the SD-100Z
will enter the power saving mode. It can be disabled or enabled power saving
function by setting Configuration Parameter # 3.
This parameter can be configured with the value of 0 through 127, where 0 means
power saving being enabled and others mean power saving being disabled.
PS: As long as the batteries have been refitted, the Sensor will enable the power
saving function automatically.
Configuring the OFF Delay
The Configuration parameter that can be used to adjust the amount of delay before
the OFF command is transmitted is Configuration Parameter # 2. This parameter can