This equipment should be installed and operated with minimum distance 20cm between
the radiator & your body.
FCC INFORMATION (additional)
OEM INTEGRATION INSTRUCTIONS:
This device is intended only for OEM integrators under the following conditions: The
module must be installed in the host equipment such that 20 cm is maintained between the
antenna and users, and the transmitter module may not be co-located with any other
transmitter or antenna. The module shall be only used with the internal antenna(s) that has
been originally tested and certified with this module. As long as 3 conditions above are
met, further transmitter test will not be required. However, the OEM integrator is still
responsible for testing their end-product for any additional compliance requirements
required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
Validity of using the module certification:
In the event that these conditions cannot be met (for example certain laptop configurations
or co-location with another transmitter), then the FCC authorization for this module in
combination with the host equipment is no longer considered valid and the FCC ID of the
module cannot be used on the final product. In these circumstances, the OEM integrator
will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
2.7 Antennas
The module has its own external antenna included and doesn't need a host's printed board
microstrip trace antenna etc.
Antenna model:
Linx 916 MHz HWR Series Antenna with RP-SMA Connector ANT-916-CW-HWR-RPS
and Linx RP-SMA to U.FL Cable CSI-RGFB-100-UFFR
2.8 Label and compliance information
In case of usage as part of other product the final end product must be labeled in a visible
area with the following: “Contains FCC ID:
2ALIB-ZMERAZBERRY7A
”. Information that
must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module in the user's manual of the end product which
integrates this module. The end user manual shall include all required regulatory
information/warning as show in this manual. The module not applicable Limited module
procedures. The module is a Single module and complies with the requirement of FCC
Part 15.24
9
.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.