illuminating, but cannot
control the ON/OFF
Switch of the load attached
the Switch has its own
ON/OFF switch
attached to ON
The Switch LED
illuminating, but the
Detector cannot control
the Switch
1. Not carry out association
2. Same frequency
interference
1. Carry out association
2. Wait for a while to re-try
LED keep flashing, but
cannot control
Overload occurs
Remove the load attached or check
max. load cannot exceed 7.5A(Resis-
tive load)
Installation Steps
1. Connect PAN30 to AC N and L.
2. Connect Load1 and Load2 to NO1 and NO2.
3. Connect external Switch to S1 and S2.
Fig 1. Assembling
IMPORTANT
Installation must be performed by skilled technicians who are
informed about the standards and technical requirements of
the appliance and its proper installation.
Check your local codes as they apply to your situation. If the
house wiring is of aluminum, consult with an electrician
about proper wiring methods.
Before proceeding with the installation, TURN OFF THE
POWER TO THE LIGHTING CIRCUIT AT THE CIRCUIT
BREAKER OR FUSE BOX TO AVOID ELECTRICAL SHOCK.
For Instruction to http:// www.philio-tech.com
DANGER
Danger of electrocution!
All works on the device may be performed only by a qualified and licensed
electrician. Observe national regulations.
Any works introducing changes into the configuration must be always performed
2
