IOMOD10F Calibration Module for Z-Wave 500 Series IC and modules - User Manual - V2.06 06/10/2017
23
1.1 IOMOD10F - Carrier Board - features
The main features of the
'IOMOD10F carrier board'
are as follows:
•
Simple
'carrier board'
which allows the
'IOMOD10F - Sigma Calibration Module'
to be used
with an external programming system.
•
Allows the
'IOMOD10F module'
to plug in via Micromatch mating connectors
•
10-way IDC connector (standard Equinox / Sigma SPI pin-out) to allow external programmer
to plug into the carrier board.
•
Connector pin for
'Oscillator Output Enable'
signal from external
•
External power connector (2-way Molex) to allow the
'Target VCC (TVCC)'
to be externally
powered if required.
•
The actual IOMOD10F module circuitry is powered from an external 3.3V supply which is
plugged into the jack socket on the IOMOD10F module itself.
•
The new
V2.00 PCB
version of the
'Carrier Board'
features an integrated 3.3V power supply
which is used to power the IOMOD10F module.
•
All other signal and power connections are available on the
'IOMOD10F module'
itself.
•
4 x mounting holes to allow the
'carrier board'
to be mounted inside a test / programming
fixture
Important note:
The
'IOMOD10F carrier board'
simply allows the routing of an external programmer to the
'IOMOD10
module'
. The
'IOMOD10F module'
must be controlled from the external programming system.
