I N ITIAL SET U P
PACKAGE I NCLU DES
4
• Z-Shade Frame and Canopy Top
(20’x10’) includes:
• Dust Cover
• 6-Piece Stake Kit
(16’x8’) includes:
• Roll Away Bag
• 12-Piece Stake Kit
• Tie Downs & Guy Ropes
Please read each step before you attempt to set up. Save these instructions for future reference.
TAKE DOWN
Grasp the top and bottom of
the truss on opposite sides.
Slightly lift canopy up and pull
hands apart while stepping
towards your partner until
canopy is 3/4 opened.
3
With partner on opposite side, grasp (2) outer legs, push frame
(slightly and shake canopy) together while stepping towards your
partner until fully closed.
Be careful not to pinch fingers
!
Store canopy in dust cover or roll away bag.
4
NOTE: Release Tie Downs prior to Take Down.
With partner, raise & slightly lift up CENTER legs, push button to
unlock and telescope inner legs into outer legs.
– Next, lift up outer legs and push button to unlock and
telescope inner legs into outer legs.
Repeat on opposite legs.
1
Release push button slider
at each corner by first
lifting fabric away from
slider. Push button slider
to release slider and
unlock from truss.
Repeat on center legs.
Note:
It is much easier to
release push button slider
when the canopy weight
has been removed from
the push button sliders.
2
Tie
Down
Push
Button
Lock
Push
Button
Lock
With partner, grasp (2) outer
legs, slightly lift off the
ground, and step backwards
– stopping at full arms’
length - approximately 3/4
its total size.
Unfold the canopy top and
place it over the open
frame. – Align all corners
of the canopy top over the
corners of the frame.
2
3
1
SET U P
Locking
Strips
With partner, lift outer legs up & slide out the INNER legs until the
push button locks into outer legs.
Repeat on opposite legs.
– Next, with partner, push button to release and adjust center legs.
Push
Button
Slider
Height Adjustment:
Press push button lock to
release and adjust legs to
desired height.
Repeat on remaining legs.
Secure the canopy top to
the frame by attaching the
canopy locking strips to the
locking strips on the frame.
Fully pull the corners down.
With partner on opposite
side, place your frame in the
center of area to be shaded.
Grasp (2) outer legs, lift off
the ground, and step
backwards - stopping at full
arms’ length.
Grasp the top and bottom of
the truss on opposite sides.
Slightly lift canopy up and
push hands together while
stepping backwards until
canopy is fully opened.
Be careful not to pinch fingers
or push too hard so as to
avoid damage to truss.
2
3
1
To engage slider at each
corner, first lift the fabric off of
the slider. Then, with one hand
hold the top of the leg while
PUSHING UP the push button
slider with other hand the
until slider engages.
Repeat on center legs.
Push
Button
Slider
Tie Downs (6):
(Available on 16’x 8’ only.)
Attach guy ropes
to stake in the ground (roughly at 45°) to support the canopy.
Repeat on remaining tie downs.
Push
Button
Lock
Push
Button
Lock
Push
Button
Lock
WARNING:
Keep all flame and heat sources away from all product fabrics. These fabrics meet the
flammability requirements of CPAI-84 and NFPA-701 specifications. The fabric may burn if left in continuous
contact with any flame source. The application of any foreign substance to the fabric may render the
flame-resistant properties ineffective. This product contains TDCPP and/or TCEP, flame retardant chemicals
known to the State of California to cause cancer, birth defects or other reproductive harm or both.
