PACKAGE I NCLU DES
• Instant Canopy Frame
• Two-Tone Polyester Top
• Roll Away Bag
• 4-Piece Stake Kit
a)
Insert extension rods in the top of the
legs to secure corner fabric to the leg.
b)
Then, pull the fabric out over the end
of the extension rods and secure using
the sewn pockets.
Repeat on all 4 corners.
4
Lift outer legs up and slide out the inner
legs until the snap button locks into the
outer leg.
Repeat on opposite legs.
5
TAKE DOWN
With partner, slightly lift up 2
adjacent outer legs, depress snap
button to unlock and telescope
inner legs into outer legs.
Repeat on opposite legs.
1
Now, with the canopy in
lowered position, remove
extension rods.
1) Pull the fabric back out
from the sewn pockets to gain
access to extension rods.
2) Carefully slide extension
rods out from the top of the
legs.
Repeat on all 4 corners.
2
Release Pull Pin at each corner
by first lifting fabric away from
slider. With one hand push up
on truss near the Pull Pin,
pull the pin out to release.
NOTE: It is much easier to
release Pull Pin when the
canopy weight has been
removed from the Pull Pin.
3
With partner on opposite
side, grasp top and bottom
area of trusses.
Lift the
canopy up slightly and shake
it while stepping towards
your partner until the unit is
3/4 closed. With each
partner grasping two outer
legs, push frame together to
fully close it.
Be careful not to
pinch fingers!
Store canopy in roll away bag.
4
Pull
Pin
a)
b)
With partner, grasp two
outer legs, slightly lift off the
ground, and step backwards
- stopping at full arms’
length.
I N ITIAL SET U P
Unfold the polyester top and
place it over the open frame.
2
Please read each step before you attempt to set up. Save these instructions for future reference.
1
Snap
Button
Snap
Button
Grasp the top and
bottom of the truss on
opposite sides. Slightly
lift canopy up and push
hands together while
stepping backwards
until canopy is fully
opened. Be careful not
to pinch fingers or push
too hard so as to avoid
damage to truss.
2
To engage Pull Pin slider
at each corner, first lift
the fabric off of the
slider, then with one
hand hold the top of the
leg while pushing up on
the slider with the other
hand. The Pull Pin will
engage the hole.
Repeat on all 4 corners.
3
SET U P
With partner on opposite side of
canopy, place your frame in the
center of area to be shaded. Grasp
outer legs, lift off the ground, and
step backwards - stopping at full
arms’ length.
1
WARNING: Keep all flame and heat sources away from all product fabrics. These fabrics meet
the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact
with any flame source. The application of any foreign substance to the fabric may render the
flame-resistant properties ineffective.
