-12-
3.4 Adjust the Recording Resolution
The resolutions can be adjusted in the general settings. The R1 dash camera
supports 1296P and 1080P front camera recording and 1080P rear camera
recording.
The rear camera options will only show when the rear cameras is connected to
the dash camera.
Front camera only:
General Settings > Resolution > 1296P /1080P
Front and Rear Camera:
General Settings > Resolution > 1296P+1080P /1080P+1080P
3.5 Loop Recording
Videos are recorded and saved to the memory card in set intervals. Once the
memory card is full, Loop Recording automatically overwrites the earliest
unprotected saved file. This prevents long duration video clips from being lost in
a single overwrite. Video files can be saved to the memory card in 1, 3 or 5
minute intervals: General Settings > Loop Recording > 1 min / 3 mins / 5 mins
3.6 Emergency Video Protection
If the G-sensor sensitivy is set to low, medum or high (see and senses an unusual
impact or collision the Dash Camera will automatically protect the currently
recorded video file from being overwritten. A EMR icon appears top left to signify
the current recording is protected and a yellow bar denotes the protected video
clip as it records.
To manually protect a video file during a recording, short press the 'Menu' button
(8).
3.7 Motion Detection
With Motion Detection enabled, video recording is automatically started when
movement is detected by the camera lens. After approximately 60 seconds with
no movement detected, video recording is automatically paused.
Enable/disable feature: General Settings > Motion Detection Mode > Motion
Detection > On / Off
Note:
Motion detection will only work if the camera is powered on. It is different from Parking Mode
that relies on a G-sensor being activated to trigger it and can be activated when the camera is
powered On or Off.
