Z Corporation ZPrinter 310, User Manual, Page: 61 / 127

61 www.zcorp-users.com
G
LUING MULTI
-
PIECE PARTS
Instructions:
1. Remove, depowder, and dry parts out of printer as described in Chapter 6, Post Processing the Part .
2. Sand seams prior to gluing and check fit of any assemblies. Sanding small parts or parts with curved
surfaces can be made easier with a small, air-powered glass air etching/sanding kit.
3. Glue seams – use of clamps can assist in the bonding process.
4. Sand the seams after they have cured to blend and smooth the edges. You may also fill the seams with
loose powder.
5. Priming, filling, and sanding before painting are critical steps in the process. Achieving the best results
sometimes requires application of two coats of primer. A wide variety of paints and primers have been
successfully used for hi-quality finishes:
•
SEM products ( www.semproducts.com )
•
Bondo ( www.bondomarhyde.com )
•
Rustoleum Acrylic ( www.rustoleum.com )
•
Interlux Brightside Polyurethane
6. You may proceed with painting the part. See instructions below for more information on painting.
Follow all safety recommendations regarding handling, storage, venting, and personal protection equipment
when using these kinds of materials. This information can be found on the Material Safety Data Sheet of each
material.