Z Automotive Tazer DT, User Manual

Page: 8 / 16

8
Perf Submenu “Perf”:
tire and performance-based options
• Set Tire Size
“ Tire ”
:
This setting will change the
programmed tire diameter. Use the hand-measured
height in inches for accurate sensor readings.
• Set Gear Ratio
“
GrRatio
”
:
This setting will
change the programmed gear ratio to match new gears
• Set Transfer Case LOW Ratio
“
4 Low
”
:
This setting will change the programmed 4Lo gear ratio.
NOTE: Use
◁
/BACK(HOLD) + /- to raise or lower
these values and
◁
/BACK(HOLD) + CRUISE On/Off to
save the setting.
NOTE: For these settings, after the required Full Reboot
and two sleep cycles , go for a 20 minute drive , preferably
highway, so that all sensors adjust. This process will assure
that the speedometer and shift points recalibrate.
Tire Submenu “Tire”:
TPMS options
• Set TPMS
“ TPMS ”
:
Change the tire pressure
monitoring system type – good when using drag radials
or winter tires when the sensors aren’t present anyway.
Can be NONE (disabled), BASE (low tire warning only), or
PREMIUM (individual tire pressure).
• Set Tire Pressures Front/Rear
“ PSI
Front/Back ”
:
This setting changes the TPMS warning
pressures – use
◁
/BACK(HOLD) + /- to raise
or lower the pressure and
◁
/BACK(HOLD) + CRUISE On/Off
to save the new
setting. The truck’s computer will only recognize a
minimum of 25 PSI.
NOTE: For these settings, after the required Full Reboot
and two sleep cycles
, go for a
20 minute drive
, preferably
highway, so that all sensors adjust. This process will assure
that the TPMS sensors recalibrate.
Radio Submenu “Radio”:
radio-based options
• Set Backup Camera
“ Cam En ”
:
This setting
enables a newly-added factory backup camera.
• Set Cargo Cam
“ CargoCam ”
:
This setting will add
the Cargo Cam selector to the camera view and activate
the input for use with a Z Automotive front camera, AV kit,
OR HDMI-AV Kit. You may only use one.
• Set DVD/CD
“ DVD_CD ”
1
:
This setting activates
the CD input on the radio, for use as an aux input,
particularly for the Z Automotive AV or HDMI-AV Kit.
• Set Travel Link
“ TravelLnk ”
:
This setting adds the
ability to disable SiriusXM Travel Link, which turns off the
weather pop-ups. Also disables SiriusXM Traffic information.
Lighting Submenu “Lighting”:
DRL and other lighting options
• Set DRL Type
“ DRLType ”
:
Choose USA (on but
selectable), Canada (on all the time) or OFF (disabled).
• Set DRL Location
“ DRL Loc ”
:
Choose which lights
to use as DRLs (results vary with vehicle model) - choices:
DRL
Turns
Low beams
• Set DRL Dropout
“ DRL Drop ”
:
Set to OFF, this
will keep the DRLs on even when a turn signal is in use.
• Set Fog Lights Enable
“ Fogs En ”
:
This
setting enables newly-added factory fog lights.
• Set Fog Dropout
“ Fog Drop ”
:
Set to OFF, this will
keep the fogs on even when the high beams are in use.
• One-touch
“ OneTouch ” enable/disable one-touch
lane change
• Set Halo Enable
“ Halo En ” enable/disable
factory halos