6
Read everything on this page CLOSELY.
CRITICAL
CRITICAL
EVERY SINGLE TIME
EVERY SINGLE TIME
YOU MAKE CHANGES IN THE “VEHICLE SETTINGS”
(ENGINE OFF) MENU
OR
OR
UNMARRY, YOU MUST PERFORM A FULL REBOOT AND TWO
YOU MUST PERFORM A FULL REBOOT AND TWO
SLEEP CYCLES.
SLEEP CYCLES.
THIS PROCESS IS EXPLAINED HERE:
*Your Tazer stores the configuration present when it’s Married. That will be what
it returns to when you Unmarry, even if it wasn’t stock.
SELECT “UNMARRY?”
“UNMARRY?”
FROM THE VEHICLE SETTINGS MENU AND PERFORM THE
AND PERFORM THE
STEPS ABOVE
STEPS ABOVE
TO RETURN YOUR VEHICLE TO STOCK CONFIGURATION*
TO RETURN YOUR VEHICLE TO STOCK CONFIGURATION*
Returning to Stock (Unmarry)
You should Unmarry and remove your Tazer before dealer service
You should Unmarry and remove your Tazer before dealer service
or if you wish to use your Tazer in another vehicle.
or if you wish to use your Tazer in another vehicle.
Full Reboots should be performed on level ground, with the wheels
Full Reboots should be performed on level ground, with the wheels
straight and with your foot off the brakes.
straight and with your foot off the brakes.
•
After making all of your changes, scroll to “
full reboot?
” and select it.
•
Wait for the countdown, then perform
two sleep cycles
.
•
The quickest way to do two sleep cycles is to turn the ignition off, open and
close the driver’s door and wait about 60 seconds AFTER the dash goes dark,
then turn the ignition on (but not the engine)
and repeat once more.
• This step is critical
after changing settings
or
settings might not save,
or you
may find that the dash doesn’t shut down, which
can result in a dead battery.
How to perform a FULL REBOOT AND TWO SLEEP CYCLES
