
Technology Center - Technical Service Department
Model 3 Power Frunk installation instruction
13.Install self-suction lock
Fix the soft closing lock in the lower right of the
original lock block with ties
(the position of the following figure)
14.Emergency pull cord fixing position
Pry off the front bumper trailer cover and tie the
emergency pull cord to the trailer cover
(position as below) note: don‘t pull the emergency
pull cord when the suction lock is normally closed,
our emergency pull cord is only used when the
suction lock is not receding.
15.Install self-suction lock
Test several times after the soft closing lock,
when the lock hook can't hang the lock ring,
adjust the two nuts at the position shown in the
figure.Tighten the pull cord
16.Connect our D4 - 1 motor free plug to the
original unlocking motor plug
(at the left frunk)
17.Status plug and limit switch plug
(frunk locking block position)
18.Power supply locationInside the hood
(original battery
〝
+
〞
)