Manual for MantraJet 1100
rev 1.03
Quick installation reference MantraJet 1100
1. Run the driver installation software on the driver CD.
2. Install the Discus Label software.
3. Place the printer on the flat leveled surface.
4. Removed plastic tight wrap from printer's tray.
5. Screw 4 CD input holders (short black rods) to the back part of the printer.
6. Insert the CD output tray into the rails on the front bottom part of the printer.
7. Insert the female part of the AC power cable to into the power supply brick.
8. Insert the small plug of the power supply to the back of the printer.
9. Connect AC cord to the outlet (Green LED on the right side of a printer should
turn on).
10. Lift printer cover.
11. Unwrap and insert a black ink cartridge (HP 27) on the right side of a carriage.
12. Unwrap and insert a color ink cartridge (HP 28) on the left side of a carriage.
13. Close printer cover.
14. Wait until printer initializes ink cartridges, look for green orange LEDs on the left
side of the printer to stop blinking. This might takes about 2 minutes.
15. Connect the printer to your computer using the USB cable. The USB connector is
located on the right side on the back of a printer.
16. Your computer should detect a new printer is connected.
17. Install the MantraJet 1100 driver using the “Install driver automatically” option.
18. Place up to 100 inkjet printable discs in the input hopper.
19. Start a Discus Label software or a preferred graphics software.
20. Congratulations – you have successfully completed printer installation. Just
select “Print”, select MantraJet 1100, enter a number of copies and enjoy.
www.MantraMediaStore.com
7
