3.
Operation
3.1 Battery installation and charging instructions
This device has a built-in rechargeable polymer lithium battery. To ensure safe
transportation, the battery connection in the battery compartment must be disconnected
during transportation! (Factory added battery separator)
Unplug the battery separator before use.
No need to disconnect the battery when the user is in normal use.
Pressing the key
continuously can power on or off the tester.
Notice: Please use the original adaptor and connected cable of the device!
When the battery icon is full or the charge indicator is always on, indicate the battery
charging is completed.
Notice: When the battery icon is full, the battery is approximately 90% charged. The
charging time can be extended for about 1 hour. Do not charge more than 12 hours on a
single charge. It can be turned on while charging, but the charging time is extended.
Notice: When the system is abnormal, please disconnect all external cables,
continuously press the key
until the instrument automatically turns off, then restart
the device.
3.2 Instrument connection
3.2.1 IP camera connection
Connect an IP camera to the LAN port of the device, connect the IP camera to the power
supply, the LINK of the LAN port of the device constantly bright, and the data indicator
flashes, indicating that the device and the IP camera are properly connected and
communicating, and the device can test the image of the camera. If the two indicators on
the LAN port of the device don’t shine, check whether the IP camera is powered on or the
network cable is faulty.
