Install-Xander_Insert_BUILT-IN_ZC - 2021-11-25.docx www.yunca.co.nz
Page 15 of 18
R10.
Rivet or screw fasten the Flue Spigot, reinsert the Primary Outer Casing Top Panel,
slipping the rear edge under the rear top panel and fasten with the two screws at the
outer corners as below:
Note
: Primary Outer Casing Top Panel must be installed after the flue is fixed in
place.
R11.
Remove the four loosely fitted, black, mushroom washer, self tapping screws from
the front edges of the firebox cowls and set them aside where you can reach them.
R12.
Set the Front Fascia temporarily in front of the fire, ready to be lifted up into position.
R13.
Reach over the top, or round the side and insert the fan power cable into the 4 pole
socket on the underside of the circuit box mounted on the rear of the fascia panel.
(The plug is shaped so it will fit only one way round.)
R14.
Lift the fascia panel, slide it over the air slide handle and sit it over the 2 pins which
project out from the side cowls. (The pins take the weight of the fascia while the
fastening screws are reinstalled and enable the fascia to easily be aligned during
installation.)
Fig. 26
