•
If the subject to be viewed is in a completely dark area, including lowlight shadow areas; activate
the infrared illuminator by pressing the “IR” button (2) located next to "ON" button.
•
Direct your Exelon 3x50 at an object at a distance of approximately 100m. Adjust the eyepiece
and objective lens diopter setting to focus the unit by rotating the eyepiece (4) and objective lens (5).
•
After the adjustment, do not rotate the eyepiece irrespective of the distance and other
conditions.
•
Direct your Exelon 3x50 at the subject to be viewed and adjust the final focus by rotating the
objective lens (5) focusing ring until the image quality is optimal.
•
When you are finished using your Exelon 3x50 put the cap back on the objective and place the
unit in the carrying case. If the green (operation status) and red indicators (IR) are lit, you need to push the
respective buttons to turn them off.
CAUTION!
Your Exelon 3x50 can be used in extreme cold. However, when the unit is brought back into a warm
environment, you MUST wait approximately 5 hours before using the unit again. Failure to do so may result in
damage as a result of condensation accumulating on the internal circuitry of the unit.
MAINTENANCE
Maintaining the Exelon 3x50 is simple:
•
Clean the lens with professional lens cleaning supplies intended for use with multicoated optics.
•
Blow any dust or dirt off the lenses using dry, compressed air.
•
Clean the Exelon 3x50 housing with a soft, clean cloth
STORAGE
Always store the Exelon 3x50 (in its case) in a dry, well-ventilated area away from heating/air
conditioning vents (or other heating devices). Temperature should be +10°C. Humidity should not exceed 70%.
Remove the battery if the device is to be stored for longer than 2 months.
TROUBLESHOOTING
•
The scope will not turn on.
Check that the battery is installed properly. Install the battery according to the (+) and (-) polarity,
ensuring that the markings on the battery and battery compartment correspond with one another. Check the
battery contact to ensure it is clean and free of corrosion; if necessary, clean the contact. Make sure that the
