•
Do not point the unit towards any light source greater than 1 lux (such as car headlights) for an
extended period of time. Long-term exposure to bright lights can damage the unit. Any such
damage may void your warranty.
•
Your Patrol 2x24 was designed to be self-contained. Do not open the body of the scope or
otherwise attempt to service this device.
•
Always store the Patrol 2x24 in a dry, well-ventilated room. Keep the Patrol 2x24 away from
any heating and air conditioning vents or other heating devices, direct sunlight.
•
Avoid dropping or otherwise shocking the unit. Although designed for rugged outdoor use, the
Patrol 2x24 incorporates a sophisticated optical system which could be damaged in extreme
cases of misuse.
•
Clean optical parts (lenses) with professional lens cleaning supplies designed for use with
multicoated optics.
•
Clean the exterior of your Patrol 2x24 with a soft, clean cloth.
Damage to this device from failure to observe these warnings may void the Patrol 2x24’s
warranty!
BATTERY INSTALLATION
Your Patrol 2x24 runs on two AAA batteries. To install, unscrew the battery compartment cover, insert
the batteries into the battery compartment so that the positive (+) and negative (-) terminals of the
batteries match the markings inside the compartment, replace the battery cover carefully. Do not
overtighten.
USE AND TESTING
Your Patrol 2x24 operates using two AAA batteries. Make sure they have been installed according to
instructions found in the battery installation section of this manual.
•
If you wish to test your night vision device in a lighted area, be sure the lens cap is in place
prior to pressing the “ON” button. The lens cap has a pinhole opening to admit a small amount
of light for testing purposes.
•
Move into a dark area before activating the Patrol 2x24 unit.
•
Remove the lens cap (1) by sliding it on the housing of the device.
•
Activate the device by pushing the "ON" button (3).
•
If the subject to be viewed is in a completely dark area, including lowlight shadow areas,
activate the infrared illuminator by pressing the “IR” Button (2) located next to "ON" button.
•
Direct your Patrol 2x24 device at an object at a distance of approximately 100 m. (110 yds).
Adjust the eyepiece and objective lens diopter setting to focus the unit by moving the lever of
