31
Firstly insert the focus canister into the base, adjust to a proper height (depend on the focus), and then it will
be OK to screw down the bolt.
And then connect the air pipe.
If height of the cutting head is needed to adjust in the future, it is only to unfasten the lockup bolt of the
focus canister for manually adjusting the height.
3.1.4.10
Software and equipment drive installation
The device is equipped with 5# control board, and the driver is attached to the product CD→Laser
engraving / cutting machine→HL series. Please consult the Motherboard Control System Operating
Manual for detailed installation methods.
Software is the SmartCarve 4.3 of our company. About software installation and use, please refer to "
SmartCarve 4.3 Software System Operating Manual
".
3.1.4.11
Other auxiliary part installation
Some types of machine are attached with other auxiliary parts (e.g. foot switch) as per request from
customers, and these parts should be installed by our customer service personnel. Moreover, users shall install
scanner, printer and other equipment prepared by themselves.
Attention
Do not adjust height of the cutting head during processing (during light emitting) to avoid
burn to human body.
The height from the cutting head to surface of workpiece is a fixed value. The value
differs due to different focuses configured.
Tips
One triangular rule is attached to the equipment for providing convenience to users to
measure and adjust height of the cutting head.
Attention
Please properly keep the CD and software encoder encryption dog attached. In case of
missing, please cont our company for purchasing.
Reinstallation of the software may cause parameter loss of the system. Please perform
backup of the related parameters before reinstalling the software or system.
Attention
The user shall protect the computer security, and do not insert unknown USB disk to
prevent virus. For common computer hardware and software failures, the user should
have basic capabilities to process.
The user shall not install other software on the computer or use the computer for other
purposes. The company is not responsible for the consequences therefrom.
