Yuel Beast Designs ATLAS Series, User Manual, Page: 18 / 19

Troubleshooting and Notes to user
Each Calypso Package comes with a bag labeled
" Troubleshooting ", this bag contains a 6-32 & 10-32 Type F
Screws. These screws are for clearing threads that might have
been compromised during powdercoating.
If you encounter a thread that is very tight, or a screw that
will not screw in , use the appropriate type F screw as a
makeshift thread tap.
Slowly tighten the screw one or two turns, then back it
compeltely out. This will remove any paint or debris in the
threaded hole without damanging the threads. Repeat the
process until the screw easily goes into the hole and the
thread looks clear.
Washers are recommended, but completely optional and
partially aesthetic. Please DO NOT use a washer on your
motherboard as this will most likely cause damage.
Type F Screw