![background image](http://html2.mh-extra.com/html/yuchai/u27/u27_instruction-manual_4668501031.webp)
2-15
5) Do not make a turn on the slope or cross the slope. Be
sure to go down to a flat place to change the position of
the machine, and then go up the slope.
6) When working on a slope, you must start from a high
place and gradually dig down the slope, with the
bulldozing board at the back and pressing the ground, and
the unloading position should be in the uphill direction.
7) Walk on grass, fallen leaves or wet steel plates at a low speed, because even in the case of a very small slope, the
machine is in danger of slipping.
8) It is strictly forbidden to turn sharply when going uphill or downhill, otherwise the machine will tip over.
9) When stopping on a slope, the front bulldozer shovel must be inserted into the soil, and the bucket must be lowered
and inserted into the soil at the same time. After the machine stops stably, the engine is allowed to stop and the driver
can get off.
Danger
Stopping on a slope is very dangerous! If it is
unavoidable, the following must be followed: if
the engine stalls on a slope, immediately lower
the bucket to the ground, and place all handles
in the neutral position, and then restart the
engine. Even if the machine stops for a short
time on the slope, lower the bucket to the
ground, pull all the handles in the neutral
position, and place enough fixed obstacles at the
lower end of the crawler track.
Summary of Contents for U27
