Yuasa JIG BASE, Instruction Manual

Page: 6 / 12

1-3
2
）
Adjust the jig base position using by the height adjustment bolt and side position adjustment bolt to the state
shown in the figure dimension.
Must adjust the jig base height at first, next adjust the side position. (Using each adjustment bolts)
Refer dimension from access hole for chamber for the Jig base position.
Front clearance and side clearance is different each chamber. Please refer from specification drawing.
3
）
Tighten a nut for each adjustment bolt after setting the jig base position completely.
Using tools
：
13 mm spanner (for the side adjustment bolt)
19 mm spanner (for the height adjustment bolt)
Tightening torque
：
8 N
･
m (for the side adjustment bolt)
30 N
･
m (for the height adjustment bolt)
* Do not over tighten the nut to break.
4
）
Put the testing jig on the jig base.
4
Top View Front View