6
Important Warnings
• Installation must be performed by a qualified installer.
• Installation must be done outside of water.
• Choose a flat area, easily accessible from the inside to mount the fixture.
• Install this fixture only on transom or sides of the hull.
• Do not use power tools to secure the fixture.
• Do not use solvents to clean the fixture.
• Do not modify whole or any part of this product.
• Wear personal protection gear during installation.
• Complete an electrical mock-up before you modify the boat.
• This is a 12V DC light fixture. Do not connect to mains or higher voltage than 15V DC.
• Do not look directly at the LEDs when in operation.
• Isolate power source prior to electrical installation.
• Each light should be individually fused.
• Do not allow exposed cable ends to come in contact with water. Capillary action will allow the ingress of water
through the cable, damaging the fixture or corroding the cable. This is not covered under warranty.
