Youshiko YC9431, Manual

Page: 8 / 10

8

The clock can be set to scan the time signal manually by holding “
▼
” and
“ ▲ “button for 3 seconds. Each reception takes about 5 minutes. If receptions
fail, scanning stops.

Stop scanning by holding “
▼
” and “
▲
“button for 3 seconds.

“
DST
” shown on the LCD if it is in daylight saving time mode.
7.2 Manual Time Setting:

Hold “MODE” button (B2) for 3 seconds to enter Clock/Calendar setting mode.

Press “
▲
” or “
▼
” button to adjust the setting and press “MODE” button to
confirm each setting.
(By keeping the “
▲
” or “
▼
” button pressed, could accelerate the process and
reach the desired value more quickly)

The setting sequence is shown as follow: 12/24 Hour, Hour, Minute, Second, Year,
Month, Day.
Note :
(1) Second adjusted to zero only.
(2) The time setting mode will automatically exit in 15 seconds without any
adjustment.
7.3 Daily Alarm Function:

Press “ MODE/SET” button to select to view:

When viewing the alarm time, hold “MODE” button for 3 seconds to enter alarm
time setting. Press “
▲
” or “
▼
” button to adjust the alarm time. Press “MODE”
button to confirm the setting.

Press “ ” button (B3) to switch alarm on or off. If it is on, “ ” shown on the
LCD.

When alarm alerting, alarm icon “ ” flash. Press “SNOOZE” button to activate
the snooze alarm, (“ ” flash on the LCD). The alarm will snooze for around 5
minutes, then it alarms again. This snooze function can be enabled for maximum
7 times.

Except “SNOOZE” button, press any buttons to stop the snooze alarm. Otherwise,
the alarm signal sounds for about 2 minutes, and then stops automatically.
Time Time & Day of Week Alarm Time ( “AL” shown on the LCD)