8
8.3 Daily Alarm Function:
Press “ MODE/SET” button (B2) to select to view:
When viewing the Alarm Time, hold “MODE” button (B2) for 3 seconds to enter
Alarm Time setting. Press “+” (B4) or “- “(B5) button to adjust the alarm time.
Press “MODE” button (B2) to confirm the setting.
Press “AL ON/OFF” button (B4) to switch alarm on or off. If it is on, “
” shown
on the LCD.
When Alarming, alarm icon “
” flash. Press “SNOOZE” button (B6) to activate
the snooze alarm, (“
” flash on the LCD). The alarm will snooze for around 5
minutes, then it alarms again. This snooze function can be enabled for maximum
7 times.
Except “SNOOZE” button, press any buttons to stop the snooze alarm. Otherwise,
the alarm signal sounds for about 2 minutes, and then stops automatically.
9. Low battery indication:
The low battery icon “
”will appear l indicating that thermo sensor is in low
battery status. The batteries should be replaced.
10.
Precautions
Use a pin to press the reset button (B1) if the Unit does not work properly.
Avoid placing the clock near interference sources/metal frames such as computer or TV sets.
The clock loses its time information when the battery is removed.
Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas
The outdoor sensor must not be set up and installed under water. Set it up away from direct
sunlight and Rain
Never clean the device using abrasive or corrosive materials or products. Abrasive cleaning
agents may scratch plastic parts and corrode electronic circuits
If there is any inconsistency of weather forecast between Local Weather Station and this unit,
the Local Weather Station's forecast should prevail. The manufacturer will not take
responsible for incorrect forecasting from this unit.
Time Time & Day of Week Alarm Time ( “AL” shown on the LCD)
