YOTON YB01, User Manual, Page: 10 / 11

1. Why is it producing a high-pitched noise ?
The units may be too close to each other.
Make sure the parent unit and the baby unit are at least 3.5 feet/ 1 meter away from each
other. The volume of the parent unit may be set too high. Decrease the volume of the
parent unit.
2. Why don't I hear a sound/ Why can't I hear my baby cry ?
(1) The volume of the parent unit may be set too low or might be switched off. Increase
the volume of the parent unit.
(2) The microphone sensitivity level of the baby unit may be set too low. Set the microphone
sensitivity level to a higher level in the parent unit's menu.
(3) The baby unit and parent unit may be out of range of each other. Reduce the distance
betvveen the units.
3. Why does the parent unit react too Strongly to unrelated sounds ?
The baby unit also picks up other sounds than those of your baby.
Move the baby unit closer to the baby (but observe the minimum distance of 3.5 feet/ 1
4. Why does the charging time of the parent unit exceed 4 hours ?
Perhaps parent unit is switched on during charging. Switch off the parent unit during
charging.
5. The specified operating range of the baby monitor is 1000 feet/300 meters. Why
does my baby monitor have a much smaller distance than that ?
The specified range is only valid outdoors in open air. Inside your house, the operating
range is limited by the number type of walls and/or ceilings in between. Inside the house,
the operating range is up to 150 feet/50 meters.
6. Why is the connection lost every now and then ? Why are there sound interruptions ?
(1) The baby unit and the parent unit are probably close to the outer limits of the operat-
ing range. Try a different location or decrease the distance between the units. Please
note that it takes about 30 seconds each time before a connection between the
units is established.
(2) You may have placed the parent unit next to a transmitter or other appliance, such
as another wireless telephone or 2.4GHz baby monitor.
Move the parent unit away from the other appliances until the connection is
re-established.
Yoton
32
bm.support@yoton.co